User Guide

Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
137
This tab displayed:
Paired devices, with the time and date of the last connection for each device
and a button to remove the pairing with that device by long press.
Pairing button : clicking on this button generates an alphanumeric pairing
code together with a QR code. This code, which will be active for the time
configured in Pairing Code Expiration Time (see section 2.1.1), has to be
entered in the remote application to perform the pairing.
This pairing process will only need to be done once, in order to link the mobile
device with the Z70 v2.
On the right side of the pop-up there are arrows to scroll through the list of paired devices.
PUSH NOTIFICATIONS
Z70 v2 incorporates the “push” notification function, which consists in notifying the mobile
devices (no matter if the remote control application has been started or not) about alarm
events:
Alarm activation: a box that has been assigned the Alarm function has either
received the alarm trigger value from the KNX bus, or exceeded the cyclical
monitoring period.
Alarm confirmation: a box with an active alarm has been acknowledged by the
user.
Alarm deactivation: a box that has already been acknowledged by the user has
also received the no-alarm trigger value. Therefore, the alarm has been
deactivated and acknowledged.
The above notifications are shown on the mobile device (unless “push” notifications are
disabled by the operating system of the device, depending on the user settings) according
to the label assigned to the involved alarm box.
Note: Zennio Avance y Tecnología S.L. does not accept any responsibility for losses of
“push” messages due to network, hardware or software failures of any kind.