User Guide

Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
135
ANNEX III. REMOTE CONTROL VIA IP
Z70 v2 feature an Ethernet interface that makes it possible to perform actions over the
device by means of remote IP applications. This brings the option to control its functions
analogously as if the device were actually being controlled on site.
Z70 V2 CONFIGURATION
In order to be able to control Z70 v2 from remote applications it is necessary that the
integrator enables in ETS the parameter Remote control through the Internet inside the
"Configuration" tab (see section 2.1.1).
Also, before being able to control the device remotely, it is necessary to make a previous
pairing between the remote application and the Z70 v2. This pairing is done in the
configuration page, where the pairing box is located.
Figure 134. Device Pairing box
In the upper right corner there is a service state indicator. This indicator will be
automatically updated if the state changes.
Service state
Icon
The device has not license for remote control
No network connection
The service is not available
Link and service OK
Remote control in process (remote device currently connected)
Table 9 Service States