User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
133
Exit: closes the dialogue without ending the call.
Mute: silences the tone of the call.
ONGOING CALL
When accepting an incoming internal call, the interface in Figure 131 will be displayed.
Figure 131. Ongoing call
The interface will have the following elements:
Hang up call: ends the communication and closes the current call dialog. The
other Z70 v2 shows the message informing that the call has ended.
Exit: has the same effect as the reject call button.
Microphone Mute: switches between mute and enable the Z70 v2 microphone.
Audio volume: changes the audio volume of the ongoing call. The selected
value will be saved for future calls.
CALL LOG
If a box is configured as internal calls (see section 2.2.2.1.5.6), a button will be available
to access a call log.
Every internal call that Z70 v2 receives or makes will be recorded as a new entry in the
call history. The information shown in each entry is as follows: