User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
128
CALL LOG
A box configured as a Video Intercom (see section 2.2.2.1.5.5) has a button to access to
a Call Log.
Every call that Z70 v2, or the other synchronized devices, receives will be registered as a
new entry in the call history. The information shown in each entry is as follows:
Figure 123. Video Intercom Log
Date and time of the call.
Whether the call has been attended , considering attended calls the accepted
and the rejected calls and those where the door has been opened from the
incoming call dialog, or not attended . Moreover, if there is a not attended
call since the last time the call log was accessed, the indicative icon appears the
video intercom box and on the page where the box is located.
Figure 124. Not attended notification (page and box)
Note: If several Z70 v2 are associated to the same GetFace IP, it is required a
synchronization between them (see section 2.1.13) to prevent inconsistent data
in the call log is recommended.