User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
127
Speakers Volume: up to 5 levels of volume available plus level 0 or mute. The
selected value is saved to apply in future calls.
Mute Microphone: toggles between mute and enable the microphone.
Exit: equivalent to reject call button.
PREVIEWING IMAGES FROM THE CAMERA
If a video intercom has been configured as a private and unit with camera (see sections
2.1.13.1.1 and 2.1.13.1.2), Z70 v2 can view the camera images from the outdoor unit by
accessing the video intercom box (see section 2.2.2.1.5.5).
When accessing the preview of the images, the interface of Figure 122 will be shown.
Figure 122. Preview panel
The interface will have the following elements:
Arrows: will appear in case of having several external units configured in Z70
v2. The arrows permit to move between the different video intercom availables.
Camera image: image captured by the camera from the video intercom selected
through the arrows located at the top.
Open Door: sends the door opening order via an HTTP command and, as
configured in sections 2.1.13.1.1 and 2.1.13.1.2, a communication object.
Note: if outdoor unit IP is not specified in the Z70 v2 settings, the preview of the camera
image and the door opening will not be accessible until at least one incoming call has been
received.