User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
126
The GetFace IP does not manifest the call rejected, so the call continues from the
point of view of the visitor.
Open Door: sends the door opening order via an HTTP command and, as
configured in sections 2.1.13.1.1 and 2.1.13.1.2, a communication object.
Besides all other synchronized screens will be notified that the call has been
answered, although the call will remain in progress.
Note: Configuring automatic door opening when receiving a call is possible (see
section 2.1.13.1.1 and 2.1.13.1.2)
Exit: the incoming call dialog is closed but no notification is sent to the bus, so
the call will continue on the rest of the synchronized screens.
Mute Call: mutes the call ringtone in Z70 v2 and the rest of the synchronized
screens will be notified.
ONGOING CALL
When accepting the incoming call, Z70 v2 shows the interface in Figure 121 and starts the
voice communication with the GetFace IP.
Figure 121. Ongoing call
During an ongoing call the functions available are:
Hang up Call: ends the communication and closes the ongoing call dialog.
Open Door: sends the door opening order via an HTTP command and, as
configured in sections 2.1.13.1.1 and 2.1.13.1.2, a communication object.