User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
123
2.3 INPUTS
Z70 v2 incorporates four analogue/digital inputs, each configurable as a:
Binary Input, for the connection of a push button or a switch/sensor.
Temperature Probe, for the connection of a temperature sensor from Zennio.
Motion Detector, for the connection of a motion detector from Zennio.
2.3.1 BINARY INPUT
Please refer to the specific user manual “Binary Inputs”, available in the Z70 v2 product
section, at the Zennio website (
www.zennio.com).
2.3.2 TEMPERATURE PROBE
Please refer to the specific user manual “Temperature Probe”, available in the Z70 v2
product section, at the Zennio website (
www.zennio.com).
2.3.3 MOTION DETECTOR
It is possible to connect motion detectors from Zennio to the input ports of Z70 v2.
Please refer to the specific user manual “Motion Detector”, available in the Z70 v2
product section, at the Zennio website (www.zennio.com).