User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
121
the action will always be shown with the parameterised text/icon. Within each
action, the time to send every action is configured.
Days of the week: set the days of the week on which sending will occur.
Type of timer:
➢ Daily/Week timer : the configured actions will be sent on the selected
days of the week without ever being disabled.
➢ One-shot timer : the actions will be sent when the configured time is
reached. Once all actions have been sent, the timer is disabled.
Note: days of the week will only be displayed when the timer is a daily/weekly
timer.
Closing the configuration panel causes the configured actions to be saved and the
checkbox to be enabled if it is disabled.
When configuring this control in ETS, the following parameters are displayed:
Figure 117. Timer
Timer Type [Binary Value / Scene]: sets the type of object to be sent when the
configured time is reached. If the Binary value option is chosen, it will be sent
through the object "[Ci] Timer - Switch Control". If the Scene option is chosen,
the following parameters will appear: