User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
120
Figure 115. Timer box
The box consists of 2 buttons. The upper button enables/disables the timer (all actions will
be displayed as --:-- if the timer is disabled), while the lower button opens the configuration
panel.
When the timer is enabled, the configured hours will be displayed in the box. In addition,
the icon will appear on the left side of the box if it has been configured as a one-shot
timer or the days of the week if it has been configured as a daily/weekly timer.
Figure 116. Timer configuration panel
Configuration panel has the following elements:
Actions to send: if binary timer is parameterised, up to 2 actions can be
enabled, one of them to send on and the other to send off, not allowing both
actions to be disabled at the same time. If scene type timer is parameterised,