User Guide

Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
116
For each of the six timed actions of each page it is necessary to select the days of the
week on which the action should be performed, as well as the specific time of day (the
first day of the week will depend on the parameterisation of screen Locale; see section
2.1.2). After that, the user should select the temperature setpoint that will be sent.
Instead of a temperature setpoint, it is also possible to send a switch-off order to the
thermostat. In such case, the user must successively press on the above control until one
of the range limits is reached, after which the word “OFF” will show on the screen instead
of a temperature value.
2.2.2.1.5.8 Scheduler
This control allows access to the general scheduler panel. To do so, it is necessary to
enable this functionality in the configuration tab (see section 2.1.1).
Figure 110. Scheduler
When the function is assigned to the box, the following parameter come up:
Default Fixed Scheduler [1 Fixed Scheduler /… / 30 Fixed Scheduler]: defines
which scheduler should be opened by default when accessing the general
scheduler panel from this box.
2.2.2.1.5.9 Macro
This control configures the sending of up to 30 orders sequentially, establishing a delay
between one order and another, defined in seconds.
The box configured as Macro looks as follows: