User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
114
Figure 106. Numeric Keypad.
For more detailed information about the functions and controls of the different dialogues
that appear in Z70 v2 in relation to internal calls functionalities, please refer to ANNEX II.
Internal Call Operation.
2.2.2.1.5.7 Chronothermostat
This control let the final user schedule the timed sending of temperature setpoints
orders (preceded by switch-on orders) or switch-off orders to a thermostat through the
objects “[Ci] Chronothermostat: On/Off” and “[Ci] Chronothermostat: Temperature”.
To that end, setting the following parameters is necessary:
Figure 107. Chronothermostat