User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
113
Figure 103. Internal Call (Box)
When the function is assigned to the box, the following parameter come up:
Figure 104. Internal call box
Interface [Contact List / Numeric Keypad]: dialog type for internal calls box. This
parameter is only available if Import contacts “from web” has been selected in
the general screen of “Internal Calls” (see section 2.1.13.2).
➢ [
Contact List]: shows a list of contacts and two arrows to go through it.
Figure 105. Contacts list
Note: The interface in Figure 105 will also be displayed if the Import contacts
“from web” option (see section 2.1.13.2) is not enabled and the contact list is
configured in ETS.
➢ [Numeric Keypad]: shows a keypad to enter the code number associated
with the contact intended to call.