User Guide

Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
107
➢ “Three Single Colour Objects (DPT 5.001)”: three 1-byte objects (“[Ci] Red
Channel”, “[Ci] Green Channel” and “[Ci] Blue Channel”) will be enabled,
which can send orders and receive statuses.
➢ “One RGB Object (DPT 232.600)”: only one 3-byte object will be enabled
(“[Ci] RGB Color”). The light levels of the three channels are sent (and
received) concatenated into the above 3-byte object.
Regarding the RGB control boxes themselves, a central label will permanently show the
colour and current light level (which is determined by the channel with the highest current
light level). This indicator gets updated automatically as the user interacts with the box,
but is also conditioned by the values received from the bus through the already described
objects.
Figure 95. RGB (Box)
Moreover, two buttons can be found in the box:
Short-pressing on the lower button permits commuting between a total absence
of light in the three channels, and their respective states previous to the switch-
off. Long-pressing it, on the other hand, will make the device send a 4-bit
dimming order through object “[Bi] Light Dimming”, analogously as the light
dimming control.
The upper button, when pressed, launches a pop-up containing a 5x6 colour
palette that permits the selection of a light level for every channel by touching
on any of the pre-set colours.