User Guide

Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
104
Figure 91 Fan Control – Auto Mode.
In case to be disabled (supposing that Speed Levels has been set to “3”),
the fan levels that can be navigated through short presses are:
Auto ( 0 )
Minimum
Medium
Maximum
On the other hand, marking the checkbox enables the one-bit object
“[Ci] (Climate) Fan Control - Auto mode”, which will trigger the Auto
mode when it receives the value “1” or “0”, depending on the subsequent
parameter Value to Set the Auto Mode [
Send 0 / Send 1]).
Figure 92 Fan Control – Dedicated Object for Auto Mode
However, in this case the Auto mode can be activated in two ways (and
mutually exclusive):
• By short press: Auto mode can be reached as a further level above the
maximum one. In this case the fan levels activated by short presses are
(note that speed 0 is optional):
( 0 )
Minimum
Medium
Maximum
Auto
• By long press on any of the buttons of the control (requires checking Long
Press to Activate Auto Mode [disabled/enabled]). A further long press
deactivates back the Auto mode
In this case the fan levels reachable through short presses are (speed 0
is optional):