User Guide
Table Of Contents
- Contents
- Document updates
- 1 Introduction
- 2 Configuration
- 2.1 General
- 2.2 Display
- 2.3 Inputs
- 2.4 Thermostat n
- ANNEX I. Video Intercom Operation
- ANNEX II. Internal Call Operation
- ANNEX III. Remote Control via IP
- ANNEX IV. Graphs
- ANNEX V. Differences with Z50 / Z100
- ANNEX VI. Communication Objects
Z50 / Z70 v2 / Z100
https://www.zennio.com Tecnical Support: https://support.zennio.com
101
activate the Cool mode. A centered indicator will reflect, as an icon, the
currently active mode.
Figure 88 Climate Control - Heat/Cool Mode
When the user activates the Cool mode, the device will send the value “0”
through the control object, while on the activation of the Heat mode the value
“1” will be sent. Moreover, the box will automatically commute between one
icon and the other every time the user executes a mode change, and also on
the reception of a new value (from the bus) through the status object.
➢ [Extended]: Selecting this type of mode control turns the box into a 2-button
control, which permit sequentially commuting among the different HVAC
climate modes. A centred indicator will reflect, as an icon, the currently
active mode.
Up to five modes [
Auto / Heat / Cool / Fan / Dry] are available, each of which
can be enabled/disabled in ETS by means of the proper checkbox, which
permits setting which of all the five extended modes will be included into the
sequential scrolling implemented by the buttons.