User manual

InZennio Z41
http://www.zennio.com Tecnical Support: http://zennioenglish.zendesk.com
74
Figure 78 Configuration screen (Configuration page)
By default, the Time/Date and Programming button controls are marked as active.
Please refer to section 2.4 for details.
On the other hand, for the Configuration page –as for any other page–, a label
(parameter Title), a box shaping (parameter Automatic page shaping; see section
2.6), and a security level (parameter Protected; see section 3.2.2) can be set.
3.7 THERMOSTAT n
Figure 79 Configuration screen (Thermostat n)
When the functions “Thermostat 1” and “Thermostat 2” from the General screen under
the Main configuration tab are enabled, the integrator will be shown two more tabs,
both similar to each other, for the parameterization of these functions independently.
Under each of the tabs, a set of screens (Configuration, Setpoint, etc.) is provided to
define the type of the thermostatic control the user will be performing from Z41.