User manual

InZennio Z41

http://www.zennio.com Tecnical Support: http://zennioenglish.zendesk.com

Note: in case of disabling a sending through [Pn][Bi] Weekly timer enabling,

the corresponding box will show the “forbidden” icon, although the box will not

lose the configuration previously set by the user.

Finally, this function offers the following parameters in ETS:

 Timer type: switches between “1-bit value” (default option) and “Scene”.

 Scene number: shown only after selecting “Scene” for the above

parameter. This field defines the number of the scene (1-64) that will be

sent to the bus on the execution of the timed sending.

Note: the execution of user-defined timers is triggered on the detection of

state transitions, even if the clock does not specifically pass through the

specified time. In other words, supposing one timed sending of the value “ON”

at 10:00h am and one timed sending of the value “OFF” at 8:00h pm, if the

internal clock is set to 9:00h pm just after 10:00h am (and therefore after

having sent the value “ON”), then the “OFF” order corresponding to 8:00h pm

will take place immediately after the time change.

f) Alarm

Figure 74 Alarm

Boxes configured as alarms perform user warnings on anomalous events. For

this purpose, boxes of this type are related to a binary object ([Pn][Bi] Alarm

trigger) that permits receiving alarm messages from the bus, thus making Z41

emit a continuous beep while the screen light blinks. In addition, the screen

will automatically browse to the page containing the alarm box that has been

triggered. After that moment, pressing on any button of the screen will

interrupt the beeps and blinks although the box will still show an intermitting

icon, which means that the alarm is still active and unconfirmed. Additionally,

the icon of the page that contains the box will also show an exclamation.