User manual

InZennio Z41
http://www.zennio.com Tecnical Support: http://zennioenglish.zendesk.com
65
monitoring the values received through the [Energy x] Power, [Energy x]
Energy, [Energy x] CO2 and [Energy x] Cost estimation objects, where
“x” is the number of the assigned channel.
Important: although it is possible to assign the “Energy monitor (KES)”
function to any box from any page, it is only possible to control as many as
six different energy channels, as it is not possible to have an exclusive
channel for each of the boxes.
 Energy consumption: determines whether the pop-up window should
show the instant value of the [Energy x] Energy object or not.
 CO2: determines whether the pop-up window should show the instant
value of the [Energy x] CO2 object or not.
 Cost: determines whether the pop-up window should show the instant
value of the [Energy x] Cost estimation object or not.
Figure 67 Energy monitor (KES). Pop-up window.
When this function is assigned to the box, two 1-bit communication objects
show up: [Pn][Bi] Energy monitor: request and [Pn][Bi] Energy monitor:
reset. The first of them is intended for sending a request from Z41 to KES
asking for the updated values of the energy measurement, which requires
having the object properly linked to the request object from KES, while the
second object will permit sending reset orders from Z41 to KES, so that all the
energy consumption, CO
2
and cost variables are set to zero, which requires
having the object properly linked to the reset object from KES. Please refer to
the user manual of KES for further information.
Evolution of the power
consumption object.
Instant value of the
Energy, CO
2
and cost
objects.
Zoom level
Validation / reset / refresh
buttons