User manual

InZennio Z41
http://www.zennio.com Tecnical Support: http://zennioenglish.zendesk.com
55
been sent the value “1.5” to the bus), it will happen that on the forth press
the value sent will be “0.5” and not “2”.
Figure 52 Relative (float) setpoint control. Object linking.
Note: the parameterized setpoint type becomes transparent to the final
user, as the aspect of the on-screen box remains the same in all cases. In
addition, the setpoint status object is always a 2-byte floating point object
and will represent, in any case, the absolute value of the current setpoint
temperature.
 Left button and Right button: permit selecting the desired icon to be
displayed inside each button in the box.
Note: the list with all the icons available in Z41 can be found in the document
“Z41 Icon list”, downloadable from www.zennio.com.
b) Mode
This function turns the box into a climate mode control.
Figure 53 Heat/Cool mode type
Two mode control types are possible: the heat / cool control type and the
extended (HVAC) control type. Selecting the former or the latter is possible
through the Mode type parameter.
Z41
Thermostat
Control object
Status object
Offset
Offset (status)
Setpoint T. (status)