User manual

InZennio Z41
http://www.zennio.com Tecnical Support: http://zennioenglish.zendesk.com
52
3.4.2.4 CLIMATE CONTROL
This category covers a set of functions related to the climate control. The available
options for Function and for the dependent parameters are as follows:
a) Setpoint control
This function permits controlling the temperature setpoint of an external
thermostat by means of a two-button box and of the parameters enabled to that
effect: [Pn][Bi] Temperature control for the control and [Pn][Bi]
Temperature indicator for the status. In addition, the box itself will
permanently reflect the value (in ºC) of the status object, whose value gets
automatically updated after sending control orders (that is, after pressing the
buttons), being even possible to receive values from the bus, for example, from
the corresponding setpoint status object from the external thermostat.
Figure 48 Setpoint control
Therefore, after every press on the temperature increment button, the bus will
be sent (through the control object) a certain value, progressively increased on
every button press until the parameterizable maximum setpoint value has been
reached. Analogously, after every press on the temperature decrement button,
the bus will be sent a progressively decreased value until the parameterizable
minimum setpoint value has been reached.
The available parameters are:
 Action: sets which of the two buttons will permit increasing the setpoint
value and which one will permit decreasing it. Options are “Left decrease,
Right increase” (default) and “Left increase, Right decrease”.