User manual

InZennio Z41
http://www.zennio.com Tecnical Support: http://zennioenglish.zendesk.com
42
c) Scene control
In this case, the central button of the box will react to user presses by sending
a scene value to the KNX bus through the [General] Scenes: send object,
which is enabled by default. Parameter Scene number permits specifying the
number of the scene (1 – 64) to be sent. Moreover, Action (which shows the
options “Run” and “Run and save”) sets whether the device will only send
scene execution orders (after a short press) or if it will be possible, in addition
to sending execution orders upon short presses, to send scene save orders in
the case of a long press.
Figure 38 Scene control
Finally, the dropdown list next to Button (in the middle) permits selecting an
icon to be displayed inside the button.
Note: the list with all the icons available in Z41 can be found in the document
“Z41 Icon list”, downloadable from www.zennio.com.
3.4.2.3 2-BUTTON CONTROL
Figure 39 2-button control (box)
Boxes configured as 2-button controls consist in an indicator and two buttons that,
when touched, trigger the sending of an action to the KNX bus through a certain object.
This category also includes some specific controls such as lighting and shutter
controls.
As a general rule, most of the 2-button controls permit configuring a pair of parameters,
Left button and Right button, each containing a dropdown list for the selection of the
desired icons to be displayed inside the buttons in the box.