User manual

InZennio Z41
http://www.zennio.com Tecnical Support: http://zennioenglish.zendesk.com
30
From the Ethernet parameter screen it is possible to give a name or description to the
device (Device description), so that identifying the device from the PC application for
the firmware update via Ethernet turns easier, as this application may detect other Z41
devices connected to the local network.
Currently, Z41 only permits automatic IP address assignment (through the DHCP
protocol). Therefore, the IP Address Assignment parameter implements no
functionality at the moment.
3.2.6 ENERGY MONITOR OBJECTS
Figure 21 Energy monitor objects (Main configuration)
This screen contains six checkboxes, each of which permits enabling or disabling one
communication “channel” that may be used for bus reception of energy consumption
reports.
Every channel implements four communication objects:
[Energy x] Power: 2-byte object to be linked to external objects reporting
power values, such as the power measuring objects implemented by KES,
the energy saver device from Zennio.
[Energy x] Energy: 4-byte object to be linked to external objects reporting
energy values, such as the energy measuring objects implemented by KES,
the energy saver device from Zennio.
[Energy x] CO2: 2-byte object to be linked to external objects reporting
volumes of CO
2
, such as those implemented by KES –the energy saver
device from Zennio– to report the CO
2
emissions corresponding to the energy
consumption.