User manual

InZennio Z41
http://www.zennio.com Tecnical Support: http://zennioenglish.zendesk.com
28
 If “Scene” is selected, the [General] Scenes: send object, already
enabled in the beginning, will work as the welcome object. In this case, the
following two parameters come up:
• Scene number: number of the scene (1-64) that will be sent to the bus.
The default value is “1”.
• Time to activate the welcome object: minimum time of inactivity (in
minutes) before a new press on the touch panel triggers the sending of
the parameterized scene. By default, it is 1 minute.
3.2.4 INTERNAL TEMPERATURE SENSOR
Figure 19 Internal temperature sensor (Main configuration)
This screen permits configuring the internal temperature sensor of the device. Three
parameters are provided for this:
Sensor calibration: permits setting a certain correction over the values
thrown by the internal temperature probe. This way, if the value of the