User manual

InZennio Z41
http://www.zennio.com Tecnical Support: http://zennioenglish.zendesk.com
26
password, the user will be required to type the corresponding old password
(level 1 or level 2). Note that although it will be possible to type password #2
even if the device asks for password #1, the new password typed afterwards
will be anyway stored as the new password for level 1.
Security pad levels: parameter consisting in six additional textboxes,
intended for the customization of the messages that the device shows (or
may show) when the user interacts with the password insertion dialog. Up to
15 characters are permitted per label.
 Label for “Password 1”: message shown when the user is required to
type in the password for level 1. By default, “Password 1”.
 Label for “Password 2”: message shown when the user is required to
type in the password for level 2. By default, “Password 2”.
 Label for “Error”: message shown to the user when the typed password
is not valid. By default, “ERROR”.
 Label for “New password”: message shown to ask the user for a new
password, during the password change process. By default, “New
password”.
 Label for “Repeat password”: message shown when the user is required
to re-type the new password. By default, “Repeat password”.
 Label for “Updated”: message shown to the user as a confirmation of the
password change. By default, “Updated”.
Buttons that lead to a protected page from the Menu page (see section 2.1) will show a
little lock icon overlaid on their lower left corner.