User manual

InZennio Z41
http://www.zennio.com Tecnical Support: http://zennioenglish.zendesk.com
23
Show temperature: sets whether the current temperature should show or not
in the upper right corner of every page, being necessary in such case to
choose the source of the temperature value: “Internal temperature probe” or
“External value”. If the latter is chosen, an object named [General] External
temperature will be enabled, so that it can be grouped with any other object
that sends temperature values.
Ethernet: checkbox (unselected by default) that activates/deactivates the
Ethernet parameter screen. See section 3.2.5.
Thermostat 1: checkbox (unselected by default) that activates/deactivates
the Thermostat 1 parameter screen. See section 3.7.
Thermostat 2: checkbox (unselected by default) that activates/deactivates
the Thermostat 2 parameter screen. See section 3.7.
Weekdays initials (Mon...Sun): field that permits customizing the label that
represents each of the weekdays within the configuration pages of the weekly
timers (see epigraph e) in section 3.4.2.5). A 7-character string (including
letters or numbers) should be entered, so each of the characters will
represent one weekday. The default value is “MTWTFSS”, according to the
initial letters of the day names in English.
Label for “Time ON”: field that permits customizing the label that will be
shown within the configuration pages of the weekly timers (see epigraph e) in
section 3.4.2.5), next to the checkbox that enables/disables the sending of
the switch-on order. The default value is “Time ON”.
Label for “Time OFF”: field that permits customizing the label that will be
shown within the configuration pages of the weekly timers (see epigraph e) in
section 3.4.2.5), next to the checkbox that enables/disables the sending of
the switch-off order. The default value is “Time OFF”.
Label for “Scene”: field that permits customizing the label that will be shown
within the configuration pages of the weekly timers (see epigraph e) in section
3.4.2.5), next to the checkbox that enables/disables the sending of scenes.
The default value is Scene”.