User manual

InZennio Z41

http://www.zennio.com Tecnical Support: http://zennioenglish.zendesk.com

3.2.1 GENERAL

Figure 14 General (Main configuration)

The General screen contains the following parameters:

Power supply voltage: lets the integrator specify the particular voltage of the

external supply powering Z41. The available values are 12 (by default), 24

and 29 volts. Selecting one option or another will only cause an internal

correction over the temperature value measured by the built-in probe.

Default theme (after programming): permits selecting the user interface

colour scheme (out of 8 different options) to be loaded after the ETS

download. The final user will have the option to switch the scheme from the

Profile page (see section 2.3), unless such option is disabled by parameter.

Show time: sets whether the current time (according to the internal clock)

should show in the upper left corner of every page. The default is “Yes”.

Screen illumination: lets defining whether the backlight should behave

during inactivity according to section 2.5 (Turn off screen), or if on the

contrary the screen should never turn off entirely (Attenuate the screen) or

not even attenuate the light level (Max illumination always).

Note: the default option is encouraged. Permanent illumination may affect

adversely the device lifetime, and is only intended for special circumstances.