User manual

InZennio Z41
http://www.zennio.com Tecnical Support: http://zennioenglish.zendesk.com
10
Note: immediately after connecting the external supply, the device will perform an
automatic calibration, which may result deviated if it takes place while any type of
pressure is being made over the front panel. In case of an unexpected behaviour in
touch recognition, it will be necessary to disconnect and connect the device back,
avoiding making pressure over the panel, in order to perform a new calibration.
After the connection of the external power supply, the screen will blink for an instant.
Approximately 7 seconds later, a welcome message containing the Zennio logo and
the “Loading…” label will be shown. Once the load process ends, the Status page will
come up (see Figure 2).
Figure 2 Status page
This screen is divided into 8 boxes:
The “KNX” box shows the individual address assigned to the screen (in case
of no assignment, this will show as “x.x.x”).
The “Software” box will show empty in absence of an application program. In
general, it will indicate if the download software is correct (“OK”) or if it is
found to be corrupt due to download issues (“ERROR”).
The “Sync” box shows, as a percentage, the progress of the internal
synchronisation of the device during the start-up. Once it reaches 100%, the
Status page will disappear and the Menu page will come up.
The “Ethernet” box shows the IP address assigned to Z41, provided that an
Ethernet cable has been attached (6) and the network is running a DHCP
server.