Operation Manual

Z41 Remote

http://www.zennio.com Tecnical Support: http://support.zennio.com

Within the Profile page: configuring the contrast, the brightness and the

audible signals is not possible remotely, although the profile selection is.

Within the Configuration page: the programming LED, device reset and

device pairing controls are not available remotely, while the time set, the

alarm log and the probe calibration do offer remote interaction (assuming they

have been enabled in ETS).

Figure 21. Controls not available on Z41 Remote.

Once the user interaction with the remote device is over, the user should finish the

session by pressing on the Close button, available on the upper right corner of the

application. Closing the session takes the user back to the main window (Figure 7).

Note: on Android, closing the session is performed by pressing on

Note: if a new communication session with the same remote device is started before 30

seconds after ending the previous session, the user will recover the control as it was before the

interruption. However, more than 30 seconds after the interruption, new sessions will always

begin from the Menu page of Z41.

In case the application is ordered to run in background, all active sessions will be interrupted.