Operation Manual

Z41 Remote
http://www.zennio.com Tecnical Support: http://support.zennio.com
19
Starting a remote control session with any of the linked devices consists in simply
pressing on its name, provided that the icon (which means the device is active and
functioning normally) or the icon (which means the device is active but containing
active alarms) are being shown next to it (in case the device was not reachable at the
moment of loading the device list, it will show the indicator – the list can be updated
at any time by pressing on the icon, in the upper right corner of the screen).
A few seconds later, a virtualisation of the Menu page of the remote Z41 or Z41 Pro will
be represented on the mobile device (Figure 20), which will look analogous to the real
Z41 or Z41 Pro interface the on-site user interacts with.
Figure 20. Z41 Connection.
From this point, the application behaves as the actual device, so the user can get rid of
learning the usage of a new interface. In addition, any action implying changes on a
control or an indicator will be notified to the real device, which will reflect equivalent
changes on the screen and will also send the KNX bus the corresponding objects,
when required.
Note that certain functions implemented by Z41 or Z41 Pro are not controllable from
the remote application (in such case, icons and indicators show faded colours):