Operation Manual

Z41 Pro
http://www.zennio.com Tecnical Support: http://support.zennio.com
83
ANNEX I. CONTROLLING Z41 PRO REMOTELY VIA IP
Z41 Pro features an Ethernet interface that makes it possible to perform actions over
the device by means of remote IP applications. This brings the option to control its
functions analogously as if the device were actually being controlled on site.
CONFIGURING Z41 PRO
In order to make the Z41 Pro control function available for remote applications, it is
necessary that the integrator specifically enables it in ETS through the Remote
Control through the Internet parameter from the “Ethernet” window, under the “Main
Configuration” tab (see section 3.2.5).
Figure 89 Configuration page with Device Paring enabled.
In addition, before being possible to remotely control Z41 Pro, it is first necessary to
pair it to the remote application. This requires that the integrator also enables the
Device Pairing parameter in the “Configuration” window, under the “Configuration
Page” tab (see section 2.4). After that, Z41 Pro will include a new icon into its
Configuration page (as in Figure 89), which lets the final user start the pairing process.