Operation Manual

Z41 Pro
http://www.zennio.com Tecnical Support: http://support.zennio.com
82
3.8 INPUTS
Z41 Pro incorporates 2 analogue/digital inputs, each configurable as a:
Binary Input, for the connection of a pushbutton or a switch/sensor.
Temperature Probe, to connect a temperature sensor (models ZN1AC-
NTC68 S/E/F and SQ-AmbienT from Zennio).
Motion Detector, to connect a motion detector (models ZN1IO-DETEC-P
and ZN1IO-DETEC-X from Zennio).
For detailed information about the functionality and the configuration of the parameters
involved, please refer to the following specific manuals, available under the Z41 Pro
product section, at the Zennio homepage, www.zennio.com):
“Binary Inputs in Z41 Pro”,
“Temperature Sensor in Z41 Pro”,
“Motion Detector in Z41 Pro”.
Notes:
The ZN1IO-DETEC-P motion detector is compatible with a variety of Zennio
devices. However, depending on the device it is actually being connected to,
the functionality may differ slightly. Therefore, please refer specifically to the
aforementioned manual “Zennio Motion Detector in Z41 Pro”.
Motion detectors with references ZN1IO-DETEC and ZN1IO-DETEC-N are
not compatible with Z41 Pro (may report inaccurate measurements if
connected to this device).
When connected to Z41 Pro, the rear micro-switch of model ZN1IO-DETEC-P
should be set to position “Type B”.