Operation Manual

Z41 Pro

http://www.zennio.com Tecnical Support: http://support.zennio.com

3.7 THERMOSTAT n

Figure 88 Configuration Screen (Thermostat n)

When the functions “Thermostat 1” and “Thermostat 2” from the General screen under

the Main configuration tab are enabled, the integrator will be shown two more tabs,

both similar to each other, for the parameterisation of these functions independently.

Under each of the tabs, a set of screens (Configuration, Setpoint, etc.) is provided to

define the type of the thermostatic control the user will be performing from Z41 Pro.

Note: for further information about the behaviour and the parameterisation of the

Zennio “Building” thermostat implemented by Z41 Pro, please refer to the specific

documentation (“Building Thermostat”) available at www.zennio.com.