Operation Manual

Z41 Pro

http://www.zennio.com Tecnical Support: http://support.zennio.com

Figure 79 Weekly Timer (Pop-Up Window).

This window contains the following elements:

 Day Selector: lets the user select the days on which the timed sending will

take place.

 Value to be Sent (ON / OFF): lets the user set the value to be sent. It can

be “ON” or “OFF”, or even both at different times. One time selector is

provided for each of the two values.

Note: if instead of the sending of a binary value, the sending of a scene

value has been parameterised, only one checkbox and one time selector

will be shown, so the user can enable/disable the sending of the scene

value and, if enabled, set the desired time.

 Time Selector: let the user set the time at which the automatic sending will

take place.

Hence, at the specified time on the days selected by the user, the bus will be

automatically sent the corresponding value through the [Pn][Bi] Weekly

Timer Control object (in the case of sending a binary value) or through the

[General] Scenes: Send object (in the case of sending a scene number). In

both cases the [Pn][Bi] Weekly Timer Enabling binary object will be

available, making it possible to disable (by sending the value “0”) or to enable

(value “1”) the execution of the timed sending set by the user. By default,

timed sending is always enabled.

Note: in case of disabling a sending through [Pn][Bi] Weekly Timer

Enabling, the corresponding box will show the “forbidden” icon, although the

Day selector

Value to be sent

(ON / OFF)

Time selector