Operation Manual

Z41 Pro
http://www.zennio.com Tecnical Support: http://support.zennio.com
63
 Allow Protection Mode: this parameter permits excluding (“No”, default
option) or including (“Yes”) the “building protection” mode from the special
modes listed in the sequential scrolling performed by the buttons.
 Left Button and Right Button: permit selecting the icon that will be
displayed inside the buttons in the box.
Note: a list with all icons available in Z41 Pro can be found in document “Z41
Pro Icon list”, available at www.zennio.com.
3.4.2.5 OTHER
Figure 64 Other
This category involves the following functions, which can be selected through the
Function parameter.
a) RGB
This function is intended for sending orders to thee-colour LED light regulators,
such as LUMENTO X3 RGB from Zennio.
Figure 65 RGB
When the function is assigned to the box, the following parameters come up:
 Object Type: permits selecting what type of object will be used for
controlling the light level of the RGB channels. It may be “Three single
colour objects (DPT 5.001)” (by default) or “One RGB object (DPT
232.600)”. If the former is selected, three 1-byte objects will be enabled