Operation Manual

Z41 Pro
http://www.zennio.com Tecnical Support: http://support.zennio.com
51
Figure 49 2-Button Scene Control
Analogously to the 1-button scene control, 2-button scene controls allows
sending the KNX bus a scene value through the [General] Scenes: send
object, however in this case there will be two buttons in the box, each of which
can be configured independently.
Through the Scene parameter it is possible to assign each of the two buttons
(left / right) the number of the scene to be sent (1 – 64). In addition, Action
(which permits the options “Run” and “Run and save”) lets the integrator set
whether the device will only send execution orders for the specified scene (after
a short press), or it will possible, apart from sending execution orders on short
presses, to also send save orders for such scene, in the case of performing a
long press on the button
Last, the dropdown list under Button Icon sets the icon to be displayed by the
buttons.
Note: a list with all icons available in Z41 Pro can be found in document “Z41
Pro Icon list”, available at www.zennio.com.
g) Shutter Control
Shutter controls permit sending move up, move down, stop or step shutter
orders to the KNX bus by pressing the buttons in the box. In addition, the box
will contain an indicator that will permanently show, as a percentage, the value
of the status object.
Figure 50 Shutter Control
The only specific parameter for this function is: