Operation Manual

Z41 Pro

http://www.zennio.com Tecnical Support: http://support.zennio.com

• Hold 0 – Release 1: one “0” will be sent when the button press starts,

and one “1” as soon as the button is released.

• Hold 1 – Release 0: one “1” will be sent when the button press starts,

and one “0” as soon as the button is released.

Finally, the dropdown list next to Button (in the middle) permits selecting the

icon to be displayed inside the button.

Note: a list with all icons available in Z41 Pro can be found in document “Z41

Pro Icon list”, available at www.zennio.com.

b) Numerical Constant Controls

If the box is assigned any of the remaining “constant” control options, the

central button in the box will react to user presses by sending a certain

numerical value, which is required to be specified under Constant value.

Figure 41 1-byte constant (unsigned int)

Table 2 shows, for every available Function, the permitted value range and the

name of the object through which the values are sent to the bus.

Function Range Object

1-byte constant (unsigned int.) 0 – 255 [Pn][Bi] 1-byte unsigned int control

1-byte constant (signed int.) -128 – 127 [Pn][Bi] 1-byte signed int control

Constant percentage value 0% – 100% [Pn][Bi] Percentage control

2-byte constant (unsigned int.) 0 – 65535 [Pn][Bi] 2-byte unsigned int control

2-byte constant (signed int.) -32768 – 32767 [Pn][Bi] 2-byte signed int control

2-byte constant (float) -671088.64 – 670760.96 [Pn][Bi] 2-byte float control

Table 2 Numerical constant controls

Finally, the dropdown list next to Button (in the middle) permits selecting an

icon to be displayed inside the button.