Operation Manual

Z41 Pro
http://www.zennio.com Tecnical Support: http://support.zennio.com
27
 If “1-bit object” is selected, the [General] Welcome Object binary object is
enabled and two more parameters turn visible:
• Value: value (“0” or “1”) that will be sent to the bus. By default it is “1”.
• Time to Activate the Welcome Object: minimum time of inactivity (in
minutes) before a new press on the touch panel triggers the sending of
the welcome object. By default, it is 1 minute.
Figure 19 Touch Lock (Time to activate the welcome object configuration – 1 bit object)
 If “Scene” is selected, the [General] Scenes: Send object, already enabled
in the beginning, will work as the welcome object. In this case, the following
two parameters come up:
• Scene Number: number of the scene (1-64) that will be sent to the bus.
The default value is “1”.
• Time to Activate the Welcome Object: minimum time of inactivity (in
minutes) before a new press on the touch panel triggers the sending of
the parameterised scene. By default, it is 1 minute.
Figure 20 Touch Lock (Time to activate the welcome object configuration - Scene)