Operation Manual

Z41 Pro
http://www.zennio.com Tecnical Support: http://support.zennio.com
24
setting one or two different passwords, so the integrator can afterwards configure
whether the access to each page will be protected by one password or another, or
remain unprotected – every page can be independently configured. Figure 16 shows
the “enter password” dialog shown to the user when trying to access a protected page.
Figure 16 Password Insertion Dialog (for password-protected pages)
In case of setting up two levels, the first one is assumed to be enclosed by the second
one. This means that whenever the device asks the user to type password #1 (to enter
a certain page); password #2 will also be accepted. On the contrary, password #1
cannot be used instead of password #2. This behaviour permits, therefore, making
password #2 available to users with further privileges while password #1 is assigned to
users with fewer privileges.
The parameters on the Security screen are:
Security Levels: dropdown list for selecting whether one (default option) or two
security levels will be available. Depending on the selection, the parameter
below (Password) may show once or twice.
Note: with independence of the option selected here, it will be necessary to
establish the security level desired for each specific page of controls.
Password: parameter made of four additional textboxes, each of which should
contain one of the four consecutive digits (0-9) that will compose the password.
The default password is “1234”.