Operation Manual
Z41 Pro
http://www.zennio.com Tecnical Support: http://support.zennio.com
15
Hence, the alarm log will contain a listing, in reverse chronological order,
where the name, time and date of every alarm event will be shown. In
addition, the log will show the current status of each of them, which may be:
“ON”: the alarm is still active or has not been acknowledged by the
user.
“OK”: the user has acknowledged the alarm event, but the
corresponding object is still in the alarm state.
“OFF”: the user has acknowledged the alarm event and the
corresponding object has already left the alarm state.
For more information on alarms, see epigraph g) in section 3.4.2.5.
IP Address: in case the device has been connected to an IP network through
an Ethernet cable (see section 1.3), the IP address it has been assigned (if
any) will be shown here.
Software Version: indicator that shows the version of the device firmware
currently installed on the device (see section 1.3.1).
Probe Calibration: control for setting a certain correction over the values
thrown by the internal temperature probe. This way, if the value of the
measurement is found to be slightly over (or below) the actual temperature
due to external factors, the final user will have the option to set an adjustment
of between -5.0ºC and +5.0ºC, in steps of 0.1ºC. In addition, it is possible to
set an initial value for such correction by parameter.
Note: any changes made on the calibration of the internal probe will be
applied beginning with the next measurement performed. Therefore, they
may not be perceived immediately.
Device Pairing: button for entering the device pairing function, which needs
to be run once on every Z41 that is intended to be controlled from a remote IP
application. See ANNEX I. Controlling Z41 Pro Remotely via IP for more
details about controlling Z41 remotely.
The labels of the controls in the Configuration page, as well as the title of the page
itself, are customisable in ETS. Moreover, it is possible to make any of the described