Operation Manual

Z41 Lite
http://www.zennio.com Tecnical Support: http://zennioenglish.zendesk.com
7
Note: immediately after connecting the external supply, the device will perform an
automatic calibration, which may result deviated if it takes place while any type of
pressure is being made over the front panel. In case of an unexpected behaviour in
touch recognition, it will be necessary to disconnect and connect the device back,
avoiding making pressure over the panel, in order to perform a new calibration.
After the connection of the external power supply, the screen will blink for an instant. A
few seconds later, a welcome screen containing the Zennio logo and the “Loading…”
label will be shown. Once the load process ends, the Status page will come up (see
Figure 2).
Figure 2 Status Page
This screen is divided into boxes, which contain the following information:
The “KNX” box shows the individual address assigned to the screen (in case
of no assignment, this will show as “x.x.x”).
The “Software” box will show empty in absence of an application program. In
general, it will indicate if the download software is correct (“OK”) or if it is
found to be corrupt due to download issues (“ERROR”).
The “Sync” box shows, as a percentage, the progress of the internal
synchronisation of the device during the start-up. Once it reaches 100%, the
Status page will disappear and the Menu page will come up.
Last, the “SW Version” box shows the version of the application program
currently loaded to the device.