Operation Manual

Z41 Lite
http://www.zennio.com Tecnical Support: http://zennioenglish.zendesk.com
67
The difference between the daily and the weekly timers is that the latter does
not permit the countdown-based sending, although it does permit that a time-
based sending takes place every week, on the days selected by the user.
Figure 76 Weekly Timer (Box).
Hence, when the user presses on the box, a window similar to Figure 77 will
pop up
Figure 77 Weekly Timer (Pop-Up Window).
This window contains the following elements:
 Day Selector: lets the user select the days on which the timed sending will
take place.
 Value to be Sent (ON / OFF): lets the user set the value to be sent. It can
be “ON” or “OFF”, or even both at different times. One time selector is
provided for each of the two values.
Note: if instead of the sending of a binary value, the sending of a scene
value has been parameterised, only one checkbox and one time selector
will be shown, so the user can enable/disable the sending of the scene
value and, if enabled, set the desired time.
 Time Selector: let the user set the time at which the automatic sending will
take place.
Day selector
Value to be sent
(ON / OFF)
Time selector