Operation Manual

Z41 Lite
http://www.zennio.com Tecnical Support: http://zennioenglish.zendesk.com
50
Note: most light dimmers implement light step dimming progressively (i.e.,
sending a dimmer a step order of 25% typically does not imply that the light
level is suddenly incremented/decremented by 25%, but a progressive
increment or decrement of the light level by 25% which is in fact interrupted if a
stop order arrives (such order is sent by Z41 Lite when the user releases the
button). Due to this behaviour, it is advised to parameterise dimming steps of
100%, so that the user can perform a complete dimming (from totally off to
totally on, or vice versa) or a partial dimming by simply holding the button and
then releasing it as soon as he gets the desired light level, therefore with no
need of performing successive long presses for regulations greater than the
parameterised step.
3.4.2.4 CLIMATE CONTROL
This category covers a set of functions related to the climate control. The available
options for Function (and for the dependent parameters) are as follows:
a) Setpoint Control
This function permits controlling the temperature setpoint of an external
thermostat by means of a two-button box and of the parameters enabled to that
effect: [Pn][Bi] Temperature Control for the control and [Pn][Bi]
Temperature Indicator for the status. In addition, the box itself will
permanently reflect the value (in ºC) of the status object, whose value gets
automatically updated after sending control orders (that is, after pressing the
buttons), being even possible to receive values from the bus, for example, from
the corresponding setpoint status object from the external thermostat.
Figure 50 Setpoint