Operation Manual

Z41 Lite

http://www.zennio.com Tecnical Support: http://zennioenglish.zendesk.com

• Toggle: pressing the button will cause an alternate sending of the

values “1” and “0”. Particularly, on the first press one “1” will be sent; on

the second, one “0”; on the third, one “1”; and so on.

• 0: one “0” will be sent whenever the button is pressed.

• 1: one “1” will be sent whenever the button is pressed.

• Short 1 – Long 0: short presses will cause the sending of the value “1”,

while long presses will cause the sending of the value “0”.

• Short 0 – Long 1: inverse to the previous case.

• Hold 0 – Release 1: one “0” will be sent when the button press starts,

and one “1” as soon as the button is released.

• Hold 1 – Release 0: one “1” will be sent when the button press starts,

and one “0” as soon as the button is released.

Finally, the dropdown list next to Button (in the middle) permits selecting the

icon to be displayed inside the button.

Note: a list with all icons available in Z41 Lite can be found in document “Z41

Lite Icon list”, available at www.zennio.com.

b) Numerical Constant Controls

If the box is assigned any of the remaining “constant” control options, the

central button in the box will react to user presses by sending a certain

numerical value, which is required to be specified under Constant value.

Figure 39 1-byte constant (unsigned int)

Table 2 shows, for every available Function, the permitted value range and the

name of the object through which the values are sent to the bus.