Operation Manual

Roll-ZAS
http://www.zennio.com Technical Support: http://zennioenglish.zendesk.com
38
Once an input is enabled, and depending on the selected input type, a new tab will be
available from the menu on the left.
3.4.1 SWITCH/SENSOR
After configuring an input as a switch/sensor, it is necessary to select the actions to be
performed on the arrival of a falling edge and on the arrival of a rising edge.
Figure 21. Input: Switch/Sensor
The available options are:
Rising Edge: sets the value to be sent to the bus when a rising edge is
detected in the input line:
 Nothing (no action is performed).
 0: object "[Ix] Edge" is sent to the KNX bus with value "0".
 1: object "[Ix] Edge" is sent to the KNX bus with value "1"”.
 Switching: "0" or "1" are alternatively sent to the KNX bus.
Falling Edge: sets the value to be sent to the bus when a falling edge is
detected in the input line: “Nothing”, “0”, “1” o “Switching”.
Sending of "0" Delay: specifies the time, in seconds, after which the value
"0" will be sent, once the corresponding edge has been received.
Sending of "1" Delay: specifies the time, in seconds, after which the value
"1" will be sent, once the corresponding edge has been received.