Operation Manual

Roll-ZAS
http://www.zennio.com Technical Support: http://zennioenglish.zendesk.com
3
DOCUMENT UPDATES
Version Modifications Page(s)
[1.5]_a
Changes in the application program:
- Optimization of the Motion Detector and Internal
Temperature Probe functions.
- Changes in the ‘Building’ thermostat function:
o Increased hysteresis range for the two-point
control.
o
Increased setpoint temperature range for the
Freezing Protection.
- Communication objects:
o
Write flag (W) of object “[General] Central
Button” enabled by default.
o Write (W) and Update (U) flags of the “[Pn][Bxy]
Enum Control” enumerated co
ntrol objects
enabled by default.
-
New range for the delay of the Initial Update function. 18
Note about the beginning of the temperature sending after
an ETS download or a bus failure.
40
Communication object table updated. 45 - 53
Minor revision of texts and internal references. -
[1.4]_a
Changes in the application program:
- Internal optimization of ETS project.
-
[1.3]_a
Changes in the application program:
- Touch locking: improvement in the management of the
locking timer to prevent undesired behaviours.
- Change in the DPTs of the lock, short-circuit and open
circuit objects.
- Minor text changes.
-
[1.2]_a
Changes in the application program:
-
Thermostat: new option to enable sending periodically
the control variable of the inactive mode as well
(parameter “Send both H/C control signals
periodically?”).
- Range of the luminosity parameters changed from 1-10
-