Operation Manual

Roll-ZAS
http://www.zennio.com Technical Support: http://zennioenglish.zendesk.com
24
First of all, two parameters are provided to set the buttons that will be destined to
navigate through the enabled pages: the Menu or the Arrow buttons. To obtain
detailed information about page switching, please refer to section 2.3.
"Pair Button Behaviour" can also be found here in order to select the desired pattern
for the buttons marked as “pair buttons” across the different pages, being the available
options Left: off/decrease; Right: on/increase and, alternatively, Left: on/increase;
Right: off/decrease.
The pages that can be enabled and configured are: Pages 1-4, the Configuration
page, the Security page, the Indicators page and the Screensaver. The next sections
explain in detail how to configure each of them..
Finally, parameter “Use the Central Area of the Touch as a Binary Button” is shown,
making it possible to enable or disable such functionality. If “Yes” is selected, a second
parameter (“Action”) will come up. This action determines whether a “0”, a “1” or an
alternating value (“Switch 0/1”) will be sent as a reaction to user presses over this
central area. This sending takes place through the “[General] Central button” specific
object.
3.3.1 PAGES 1-4
For every enabled page, up to 8 individual buttons or up to 4 pair buttons can be
enabled. According to the selected configuration, each button can perform different
functionalities, which are explained in detail below.
Note: the options and screenshots shown may refer to Page 1. However, they would
be analogous for pages 2-4.
Figure 16. Page 1. Configuration