Operation Manual

Roll-ZAS
http://www.zennio.com Technical Support: http://zennioenglish.zendesk.com
23
continuous re-sending of these objects when the temperature fluctuates
continuously around the limit.
Contrast Level: the initial contrast level (0-20) of the display can be set here.
This value may be changed later by the final user, if the contrast function of
the Configuration page is activated.
Buzzer Object: associated to this parameter is a 1-bit communication object,
"[General] Buzzer", which will make ZAS emit a short beep when it receives
the value "1". The value "0" does not have an effect.
Note: keep into account that beeps will only take place if the buzzer function
is active (“[General] Buzzer enabling” = 1).
3.3 PAGES
From this section it is possible to enable and configure individually the pages to be
implemented in ZAS.
Figure 15. Page Configuration Window