Operation Manual

InZennio Z41
http://www.zennio.com Tecnical Support: http://support.zennio.com
76
Figure 82 Chrono-thermostat (pop up)
Each box configured as a chrono-thermostat contains four pages with six
customisable timers each, being possible for the user to configure up to 24
timed actions.
The buttons on the bottom of the window let switching across the four pages,
as well as closing the pop-up window (button ).
For each of the six timed actions of each page it is necessary to select, on the
first hand, the days of the week on which the action should be performed, as
well as the specific time of day.
After that, the user should select (through controls and ) the
temperature setpoint that will be sent. The range of this value is restricted
by parameters “Minimum Setpoint Value” and “Maximum Setpoint Value”.
Note: the timed sending of a temperature setpoint is always preceded by a
switch-on order.
Instead of a temperature setpoint, it is also possible to send a switch-off
order to the thermostat. In such case, the user must successively press on the
above control until one of the range limits is reached, after which the word
“OFF” will show on the screen instead of a temperature value.
On the other hand, it is possible to activate or deactivate each action
separately by marking its corresponding checkbox. While this checkbox
remains unmarked, the action configured will not take place.