Operation Manual

InZennio Z41
http://www.zennio.com Tecnical Support: http://support.zennio.com
75
f) Chrono-thermostat:
Boxes configured as chrono-thermostats let the final user schedule the timed
sending of temperature setpoint orders (preceded by switch-on orders) or
switch- off orders to a thermostat through the KNX bus.
To that end, it is necessary to configure the following two parameters:
Figure 80 Chrono-thermostat
 Minimum Setpoint Value: minimum setpoint value the user will be able
to set. Range: [-20, 95] x 1ºC. Default value: 18ºC.
 Maximum Setpoint Value: maximum setpoint value the user will be able
to set. Range: [-20, 95] x 1ºC. Default value: 30ºC.
When a box is configured as a chrono-thermostat, it looks as follows:
Figure 81 Chrono-thermostat (box)
The switch button on the left activates / deactivates the chrono-thermostat,
that is, resumes or stops the execution of the timed actions that may have
been configured (the configuration is not lost during the deactivation). While
the chrono-thermostat is not active, icon is shown next to the switch button.
On the other hand, when the user touches on the calendar icon, a new
window will pop up to let the user set the actions to be executed: