Operation Manual

InZennio Z41

http://www.zennio.com Tecnical Support: http://support.zennio.com

Through the Scene parameter it is possible to assign each of the two buttons

(left / right) the number of the scene to be sent (1 – 64). In addition, Action

(which permits the options “Run” and “Run and save”) lets the integrator set

whether the device will only send execution orders for the specified scene (after

a short press), or it will possible, apart from sending execution orders on short

presses, to also send save orders for such scene, in the case of performing a

long press on the button

Last, the dropdown list under Button Icon sets the icon to be displayed by the

buttons.

Note: a list with all the icons available in Z41 can be found in document “Z41

Icon list”, available at www.zennio.com.

g) Shutter Control

Shutter controls permit sending move up, move down, stop or step shutter

orders to the KNX bus by pressing the buttons in the box. In addition, the box

will contain an indicator that will permanently show, as a percentage, the value

of the status object.

Figure 50 Shutter Control

The only specific parameter for this function is:

 Action: sets which of the two buttons will send the move up orders and

which the move down orders. Options are “Left Down, Right Up” (default)

and “Left Up, Right Down”.

Setting up a box as a shutter control enables three communication objects,

[Pn][Bi] Shutter Position (1 byte), [Pn][Bi] Move Shutter and [Pn][Bi] Stop

Shutter (both, binary objects). The former acts as the status object, which

determines the value shown in the box; it will be necessary to link it to the

analogous object from the shutter actuator (as it does not get automatically